Cubase 6 automation loop problem

Post questions and find answers on our Cubase 6 releases here.

Cubase 6 automation loop problem

Postby vladpov » Tue Oct 08, 2013 5:55 pm

I have a problem with automation in Loop mode.
If i want to EQ a single phrase or just a few bars and have the EQ faders go back to zero after the phrase.
I select the range of the phrase, set the automation to Loop and Touch, write enable it, turn on the relevant EQ module and click/move around the curve point. When i leave the mouse two automation points appear, in and out of the range. So far so good.
The problem is with the "out" point. The "in" point is at whatever value that it had before, most often zero. But the "out" will be at the value that it had when i left the mouse.
If i do more changes to the EQ the "out" point will remain at the value it got on the first pass, but i need to be back at zero.
The same with the module on/off parameter. If it's turned on during the first pass the "out" point will remain "on" and not "off" like it was before.
So if i want to EQ a single phrase i have to turn the modules off and reset them manually to zero after editing.
Very annoying.
I checked the manual and there's no explanation for this behavior. This is how the Loop mode is pictured:
Operation_Manual.jpg
(64.37 KiB) Not downloaded yet

The value at the right locator is different from the left locator.
Sorry, if i repeat another post, couldn't find a solution for this.
vladpov
New Member
 
Posts: 1
Joined: Thu May 24, 2012 12:00 pm
Has thanked: 0 time
Been thanked: 0 time

Return to Cubase 6 | Cubase Artist 6 | Cubase Elements 6

Who is online

Users browsing this forum: No registered users and 2 guests