jatzemann wrote:hey people,
in my recent project in cubase 6.5 I have following problem:
I´ve loaded several instances Kontakt 5 in my vst-rack. one instance is only for the brass, e.g. trp, flgh, trb, tuba...
all these vst-instruments are midi-tracks and are sent to this special instance Kontakt.
now I´d like to do a delay-automation ONLY for ONE of the vst-instruments.
is this possible???
if it would be an instrument-track I´d know how to do it. I load the delay as insert-effect and just do the automation.
BUT it seems to be impossible to write an automation for a midi-track?! isn´t it?!
the only way I find is to do the automation for the whole instance Kontakt, but so it´d be for all of the loaded instruments for this instance.
for sure I could separate this one instrument and open it as an instrument-track BUT this project is on its limit respect the cpu so I´d prefer to find a solution to remain it inside of the instance Kontakt and do the automation there.
so, any good ideas???
many thanks in advance!!
thanks a lot for this helpful reply !!!
so, i have to find out how to do separated buses in kontakt; i didn´t even know that this was possible!!
for which term should i look for in the user manual??
for sure, when i master to do this i´ll only open one instance of kontakt and load all my instruments there.
(my actual project has already 6 instances kontakt!!) ;-(((
Users browsing this forum: No registered users and 4 guests