I'm using two MR's connected via ADAT to an RME UFX.
I think what you need to do is this:
1. Connect the first MR to your computer using a Firefire cable, then run the MR-Editor program and on the Setup page set the clock to 'Internal' and 44 or 48 sample rate.
2. Then connect the second MR using the Firewire cable and set the clock source to 'ADAT' and the same sample rate as the first MR.
3. Disconnect the Firewire cable from the second MR, re-connect it to the first MR and connect the ADAT IN/OUT cables between the two machines as normal.
It should then work.
Last edited by fenderchris
on Thu Nov 24, 2011 5:48 pm, edited 1 time in total.
The Archers - give it a rest already!
i7 Quad core 2.66 15GB ram, Windows-7 64-bit, Nuendo-5.5.6 64-bit, Wavelab-6, 2x MR816CSX, RME FireFace UFX, SmartAV Tango, MOTU Express 128, UAD-2 Quad, Lexicon PCM-91, Lexicon MPX-500, TC-Fireworx, Halion-5, Kontakt-5, Roland V-Drums TD-20X
Omnisphere, Trillian + loads of real instruments.