Cubase 10.5.12 - cannot select the recorded part to edit

After recording audio, the part cannot be selected - as if it is a “ghost” part.

The only option seems to be to close Cubase and re-open the project, which then allows the part to be selected and edited.

Running Cubase 10.5.12 on a Macbook with 10.14.6 Mojave OS.

Hi and welcome,

This sounds familiar to me. If I remember, some user had this issue in the past already. But unfortunately I don’t remember the solution. Try to search here on the forum, please.

Could you try in Cubase Safe Start Mode, please?

Hi Martin,

I searched through the forum but could not find a good match for his issue.
Your advice pointed me in the right direction though - as I tested out a new project, which did not have this issue. :smiley:
So the problem was in my project file. Whenever I closed the old project it produced a crash dump.

I created a new project, opened the one with an issue, selected all and pasted into the new active project. I then went through duplicating the settings from the old project to new and have cleared the fault.

Many thanks and hope that this fix helps someone else if they have this issue.

Paul