Hi There
I have recently purchased Cubase 7 and the CMC-CH controller. These have both been registered on my new Steinberg account. I am running Windows 7 64Bit, with Cubase 64Bit installed.
For some reason I cant get my CH controller to work.
I have run the setup for 64Bit from the CMC Tools disk, and the unit does come on and is responsive to touch etc. However Cubase does not seem to pick it up.
I have gone to “Device Setup”>Remote setup, but it still reads nothing. I have plugged in the unit before opening Cubase as stated.
I logged onto the hub and installed the latest Driver but still nothing. I have also updated Cubase 7 to 7.0.1
I have checked the forums and this seems to be a common issue among these controllers, but with no clear solutions.
Any help would be greatly appreciated.