Spectrum View & Spectral Editor Switching Issue

WaveLab
3

Unless otherwise stated, I will refer to the main view, not the top view.

  1. I’m in Waveform View.
  2. I switch to Spectrum View. Spectrum View comes up fine.
  3. I switch to Spectrum Editor to fix a problem in the audio.
  4. I switch back to Waveform View.
  5. I switch to Spectrum View. Except now instead of Spectrum View, Spectrum Editor comes up.
  6. I switch between Waveform View and Spectrum View but Spectrum Editor keeps coming up instead of Spectrum View.
  7. The only way I can “reset” the Spectrum View tab back to Spectrum View is to click the Spectrum View in the TOP view. (Incidentally, when I click the top view spectrum view tab, the program freezes for approximately 10 seconds before the view changes.)
  8. Now, everything works as it should again. UNTIL I go back into Spectrum Editor. Problem happens again.