Any particlar reason that my M-audio Projectmix is not working?
Its setup but no plugin automates.
I will have to try the tutorial again.
So far I can get the MCB to load into my LCD but none of the below show in the LCD.
- Output
- Bypass
- Threshold1
- Ratio1
- Attack1
- Release1
- MakeUp1
my PJ is setup as a mackie Control with midi set as i/o
I also setup the “Control surface midi” in the “Quick controls”
Other then that my PJ works perfect as a fader controller.
(My PJ Knobs are factory set at
CC 0 CH 2,
CC 1 CH 2,
CC 3 CH 2,
CC 4 CH 2,
CC 5 CH 2,
CC 6 CH 2,
CC 7 CH 2,
CC 8 CH 2,