Did you restart Cubase after starting Yoke?
There might be a problem with Yoke on 64-bit systems, I don’t remember. Make sure you see it in Cubase, in the generic remote section.
The mapper takes certain messages, and replaces them with the other messages. Ranges are mapped in sequence.
In your image, it maps NRPN number 96 with data between 0 and 1 to Ctrl 54 with value 64.
Make it look like the attached image (ignore the lines marked in red).
This should map INC to 1 and DEC to 16383.
Set the controllers to relative in Cubase.
In the XML, you should have flags set to 21, for example:
Untitled201001638321
I’ve tested it now on my setup and it seems to work.
Just note that if you want it to move faster, you’ll have to tweak the parameters, I’ll explain if needed.
