Setting up External Effects

willynanita · November 19, 2013, 7:14pm

thinkingcap:

willynanita:

Hello!

I just configured an external effect with Cubase and my Soundcard. It works fine with one minor detail that I don’t know how to fix. (BTW: I didn’t linked the effect to a midi device, the manual says I need to do that, but I don’t know exactly how to do it, it works without it)

You don´t need to do that.

willynanita:

I am sending a stereo signal to the external effect via output 3 and 4 from my soundcard (1 and 2 are connected to the monitors). Then I send the signal back to the soundcard/cubase using intputs 3 and 4 (1 and 2 are the front mic inputs).

The problem is all tracks are being sent to the external effect at all times. How do I set this up so only the tracks I want to use the effect, is sending their signal, is that even possible?

If Cubase is configured correctly, then you need to learn how to setup the scarlett mixer

Thanks for the reply!

I needed to setup the Scarlett correctly for the external effect to work only on the tracks that is activated. It’s working as it should now.