Yes, RANGE = The time/bars between the left & right locators.
My screen shot slooks the same as yours when I make a loop, even if I’m not using “inserted cycle mode.” But I THINK I’ve finally figured it out. You tell me if I’ve got this right now.
- You must first have a Marker track loaded to make Insert Cycle Mode (ICM) work.
- The range indicator/L-R Markers WILL CHANGE AT EACH INSERTED CYCLE MARKER.
- You can NOT overlap ranges (ie: (ICM-1) Bar 50 to 60 (ICM-2) Bars 58 to 72 not possible. But (ICM-1) Bar 50 to 60 with (ICM-2) Bars 72 to 80 will work just fine).
- When you leave insert cycle mode YOU WILL HAVE TO RESET YOUR END LOCATOR POINT.
If all of the above is correct, then my question has finally been answered.
