For my purposes, I WILL HAVE TO OMIT THE MARKER TRACK. If the marker track is inserted into the project the insert marker mode will work. The problem is that, once it’s on, you can’t turn it off. By that I mean that even though the loop function is off, the locate points keep changing to current location with no end point listed.
Screen shot 1 shows no marker track L/R points go from Bar 003 to Bar 140.
I can jump to any of my 21 locate markers and those parameters will not change.
Screen shot 2 shows the same project with the marker track inserted. Note that the cycle icon is not activated. Yet, when I select a locate point (in this case Bar 31), both of my L/R markers now say Bar 31.
My end marker of Bar 1401 is now gone. Since you can’t de-activate a marker track (as you can with an audio or MIDI track), my only option is to leave the track out and only insert it when I need to activate any of the cycle points.
It sure would’ve been nice to have those factors listed in the manual. Anyway, the mstery is now solved. Thanks so much for your help! 