Nuendo 4 -Stereo Export Problem

For users of legacy Steinberg Nuendo software
Post Reply
HiddenGemRecords
New Member
Posts: 1
Joined: Sun Aug 05, 2018 10:19 pm
Contact:

Nuendo 4 -Stereo Export Problem

Post by HiddenGemRecords » Sun Aug 05, 2018 10:30 pm

Hey guys,

Ive been using N4 forever and I recently switch my intergace from RME to UA Apollo. I assigned my drivers and buses, but when I try to export an “existing” song to a single stereo file, it is not in stereo.

I try a new song from scratch with some basic tracks, and exporting to a songle stereo file workes fine. (I panned a few tracks hard right/left, and it was fine.

Back to othe existing songs in the works, I cannot mix them down in “stereo,” without clicking on “split tracks.”
Its strange I made sure the vst connections are all correct in my device setup and cant figure this out?

Anyone have any suggestions?

I can only think it has something to do with switching interfaces on an existing song? Any help appreciated.

Greg

Post Reply

Return to “Older Nuendo versions”

Who is online

Users browsing this forum: No registered users and 1 guest