UR44 inputs & monitoring with Logic Pro X

[Jason Soditch]

Hi,

I am looking for help regarding how to stop the audio coming into the UR44 interface's inputs from immediately being routed to the main monitor output. I am using Logic Pro X, and would prefer to only hear the audio coming into the UR44 when input monitoring a Logic audio track that's been assigned a UR44 input (3/4, 5/6, etc.). As it is now, whatever audio is coming in to the UR44 is being routed to my monitors regardless of whether or not I have created an audio input in Logic, and it's mono even though I'm coming in stereo via inputs 3/4. If I do have an audio input in Logic, and have it record or input-enabled, as well as having 'software monitoring' enabled, I can then hear the audio in stereo, but ALSO the mono version that I mentioned before, and it's obviously phasing and annoying.

Thanks in advance for your help!

[cupsncakespod]

Sorry man,

You seem to know way more about this stuff than me. I only use my UR44 for a podcast... 4 mics and thats it. As for Logic, I just know enough to get by.

Jeff

[Jason Soditch]

No problem. Thanks for checking it out!

[misohoza]

Hi.

If you don't want to use the direct monitoring, mute the corresponding inputs in DspMix app (or solo the Daw channel).

If you are using direct monitoring and are recording a stereo source, pan the pair of inputs in DspMix hard left and hard right.

[Jason Soditch]

Thank you so much!

[janbaars]

just mute the input in 'MIX 2'