Cmc pd macros and logical presets

This section is about Steinberg's CMC controllers
Post Reply
Pablo1980
Member
Posts: 203
Joined: Wed Dec 15, 2010 4:54 pm
Contact:

Cmc pd macros and logical presets

Post by Pablo1980 » Fri Sep 16, 2016 11:33 am

Hi, the title says it all. Can I use the PD for macros and logical presets or they must only be key commands?
Thanks!
Film Composer - Argentina

Intel 3930k - Gigabyte x79s-up5 wifi - 32gb ram - Motu 24ao - Steinberg MR816x (2)
Windows 10 64bit - Cubase 9.5 Pro - Vepro 6

delgado
Junior Member
Posts: 88
Joined: Fri Apr 15, 2011 6:25 pm
Contact:

Re: Cmc pd macros and logical presets

Post by delgado » Thu Nov 24, 2016 8:29 pm

In Cubase, you can program the PD to execute Macros (in the device setup page). Bank 16 of the PD gives you the entire 16 pads assignable at will.
i7 4930k/P9X79/32GB DDR3 RAM
RME 9632 PCI on PCIe slot (bridged)
CMC, Alphatrack, Contour Shuttle controllers
Cubase 9.5.10., Samplitude ProX3 Suite
Dorico 1.2, Sib8.5,
Win10pro 64bit

Pablo1980
Member
Posts: 203
Joined: Wed Dec 15, 2010 4:54 pm
Contact:

Re: Cmc pd macros and logical presets

Post by Pablo1980 » Fri Nov 25, 2016 12:57 am

Thanks! I bought it and it works fine, but sometimes it "disconnects" and I have to restart and unplug the usb cable so cubase can recognize it again.

Have you had this problem?
Film Composer - Argentina

Intel 3930k - Gigabyte x79s-up5 wifi - 32gb ram - Motu 24ao - Steinberg MR816x (2)
Windows 10 64bit - Cubase 9.5 Pro - Vepro 6

delgado
Junior Member
Posts: 88
Joined: Fri Apr 15, 2011 6:25 pm
Contact:

Re: Cmc pd macros and logical presets

Post by delgado » Fri Nov 25, 2016 1:45 am

not so far Pablo, I only just got all the CMCs in a bundle sale and am yet to really test them. Looking good so far though on 8.5 and win 10/64
i7 4930k/P9X79/32GB DDR3 RAM
RME 9632 PCI on PCIe slot (bridged)
CMC, Alphatrack, Contour Shuttle controllers
Cubase 9.5.10., Samplitude ProX3 Suite
Dorico 1.2, Sib8.5,
Win10pro 64bit

Post Reply

Return to “Steinberg CMC Series”

Who is online

Users browsing this forum: No registered users and 1 guest