Page 1 of 1

Is it possible to link btween event and automation?

Posted: Fri Sep 04, 2015 10:37 am
by drorh4
Hey,

Every time Im working on some event and making some automation, and after a while, I edit the event or move it a bit, the automation is moving with the event BUT the old area stays automated.

Even when event get trimed..the automation stays the same.

Re: Is it possible to link btween event and automation?

Posted: Fri Sep 04, 2015 1:26 pm
by Oswald Schwander
Could be a reason to take a look at Nundo 7. Automation now gets trimmed as you expect.
In addition, the option “Automation follows events” now applies for trimming head/tail of events, making editing a lot easier, as automation curves will be written even if the audio event is shortened or extended.
Oswald