Page 1 of 1

«f2» for openning panel is not showing it.

Posted: Sun May 18, 2014 5:44 pm
by gasto
I press «f2» or click on the tools->panel menu to open the panel but to no avail, this just happens in one project, I suspect I left it out of the range of sight in the main windows, so no I can't move it back to a place where I can watch and manipulate it.

Any suggestions?

Re: «f2» for openning panel is not showing it.

Posted: Fri May 23, 2014 2:30 am
by gasto
Since I have dual monitors, I had to open a project in which the transport panel was open in the right hand side monitor so that I could bring it back to the lef sided monitor.