Hallo Ihr geplagten Cubase Nutzer,
ich möchte mich traurigerweise einreihen in diese Reihe. Ich habe ein relativ frisch zusammen gebautes System und massiv mit Reak-Time-Peaks zu kämpfen.
Ich poste euch mal den LatencyMon Status hier rein und hoffe sehr auf Hilfe und Tipps wie ich meine System performant bekomme. Vielen Dank schonmal im Voraus
CONCLUSION
Your system appears to be suitable for handling real-time audio and other tasks without dropouts. (das ist halt voll lächerlich, bereits bei ein paar Spuren kommt es zu Peaks
)
LatencyMon has been analyzing your system for 0:14:14 (h:mm:ss) on all processors.
\
SYSTEM INFORMATION
OS version: Windows 10 , 10.0, build: 17763 (x64)
Hardware: ASUSTeK COMPUTER INC., PRIME X470-PRO
CPU: AuthenticAMD AMD Ryzen 7 2700X Eight-Core Processor
Logical processors: 8
Processor groups: 1
RAM: 32688 MB total
\
CPU SPEED
Reported CPU speed: 3693 MHz
Note: reported execution times may be calculated based on a fixed reported CPU speed. Disable variable speed settings like Intel Speed Step and AMD Cool N Quiet in the BIOS setup for more accurate results.
WARNING: the CPU speed that was measured is only a fraction of the CPU speed reported. Your CPUs may be throttled back due to variable speed settings and thermal issues. It is suggested that you run a utility which reports your actual CPU frequency and temperature.
\
MEASURED INTERRUPT TO USER PROCESS LATENCIES
The interrupt to process latency reflects the measured interval that a usermode process needed to respond to a hardware request from the moment the interrupt service routine started execution. This includes the scheduling and execution of a DPC routine, the signaling of an event and the waking up of a usermode thread from an idle wait state in response to that event.
Highest measured interrupt to process latency (µs): 134,30
Average measured interrupt to process latency (µs): 4,458661
Highest measured interrupt to DPC latency (µs): 129,80
Average measured interrupt to DPC latency (µs): 1,815477
\
REPORTED ISRs
Interrupt service routines are routines installed by the OS and device drivers that execute in response to a hardware interrupt signal.
Highest ISR routine execution time (µs): 126,950176
Driver with highest ISR routine execution time: dxgkrnl.sys - DirectX Graphics Kernel, Microsoft Corporation
Highest reported total ISR routine time (%): 0,121561
Driver with highest ISR total time: dxgkrnl.sys - DirectX Graphics Kernel, Microsoft Corporation
Total time spent in ISRs (%) 0,130371
ISR count (execution time <250 µs): 973770
ISR count (execution time 250-500 µs): 0
ISR count (execution time 500-999 µs): 0
ISR count (execution time 1000-1999 µs): 0
ISR count (execution time 2000-3999 µs): 0
ISR count (execution time >=4000 µs): 0
\
REPORTED DPCs
DPC routines are part of the interrupt servicing dispatch mechanism and disable the possibility for a process to utilize the CPU while it is interrupted until the DPC has finished execution.
Highest DPC routine execution time (µs): 185,741403
Driver with highest DPC routine execution time: nvlddmkm.sys - NVIDIA Windows Kernel Mode Driver, Version 430.39 , NVIDIA Corporation
Highest reported total DPC routine time (%): 0,095128
Driver with highest DPC total execution time: Wdf01000.sys - Kernelmodustreiber-Frameworklaufzeit, Microsoft Corporation
Total time spent in DPCs (%) 0,276943
DPC count (execution time <250 µs): 3962420
DPC count (execution time 250-500 µs): 0
DPC count (execution time 500-999 µs): 0
DPC count (execution time 1000-1999 µs): 0
DPC count (execution time 2000-3999 µs): 0
DPC count (execution time >=4000 µs): 0
\
REPORTED HARD PAGEFAULTS
Hard pagefaults are events that get triggered by making use of virtual memory that is not resident in RAM but backed by a memory mapped file on disk. The process of resolving the hard pagefault requires reading in the memory from disk while the process is interrupted and blocked from execution.
NOTE: some processes were hit by hard pagefaults. If these were programs producing audio, they are likely to interrupt the audio stream resulting in dropouts, clicks and pops. Check the Processes tab to see which programs were hit.
Process with highest pagefault count: cubase8.exe
Total number of hard pagefaults 2887
Hard pagefault count of hardest hit process: 2783
Number of processes hit: 4
\
PER CPU DATA
CPU 0 Interrupt cycle time (s): 43,581147
CPU 0 ISR highest execution time (µs): 126,950176
CPU 0 ISR total execution time (s): 8,869713
CPU 0 ISR count: 926983
CPU 0 DPC highest execution time (µs): 185,741403
CPU 0 DPC total execution time (s): 18,794236
CPU 0 DPC count: 3926625
CPU 1 Interrupt cycle time (s): 4,069532
CPU 1 ISR highest execution time (µs): 19,857568
CPU 1 ISR total execution time (s): 0,005202
CPU 1 ISR count: 5892
CPU 1 DPC highest execution time (µs): 120,317628
CPU 1 DPC total execution time (s): 0,015054
CPU 1 DPC count: 5572
CPU 2 Interrupt cycle time (s): 4,325135
CPU 2 ISR highest execution time (µs): 3,937449
CPU 2 ISR total execution time (s): 0,005080
CPU 2 ISR count: 5738
CPU 2 DPC highest execution time (µs): 59,282155
CPU 2 DPC total execution time (s): 0,020238
CPU 2 DPC count: 7069
CPU 3 Interrupt cycle time (s): 4,173688
CPU 3 ISR highest execution time (µs): 3,616843
CPU 3 ISR total execution time (s): 0,003840
CPU 3 ISR count: 4535
CPU 3 DPC highest execution time (µs): 50,325210
CPU 3 DPC total execution time (s): 0,011233
CPU 3 DPC count: 4237
CPU 4 Interrupt cycle time (s): 4,759802
CPU 4 ISR highest execution time (µs): 3,015705
CPU 4 ISR total execution time (s): 0,002402
CPU 4 ISR count: 3053
CPU 4 DPC highest execution time (µs): 43,732738
CPU 4 DPC total execution time (s): 0,009051
CPU 4 DPC count: 2786
CPU 5 Interrupt cycle time (s): 4,645392
CPU 5 ISR highest execution time (µs): 3,636881
CPU 5 ISR total execution time (s): 0,006290
CPU 5 ISR count: 8132
CPU 5 DPC highest execution time (µs): 43,462226
CPU 5 DPC total execution time (s): 0,018901
CPU 5 DPC count: 6521
CPU 6 Interrupt cycle time (s): 4,633894
CPU 6 ISR highest execution time (µs): 6,001354
CPU 6 ISR total execution time (s): 0,005070
CPU 6 ISR count: 6564
CPU 6 DPC highest execution time (µs): 45,656377
CPU 6 DPC total execution time (s): 0,017807
CPU 6 DPC count: 4659
CPU 7 Interrupt cycle time (s): 5,103677
CPU 7 ISR highest execution time (µs): 5,119686
CPU 7 ISR total execution time (s): 0,009336
CPU 7 ISR count: 12873
CPU 7 DPC highest execution time (µs): 58,500677
CPU 7 DPC total execution time (s): 0,034219
CPU 7 DPC count: 4951