Macro Page designer crashed again

Use this forum for an overview of collected bugs and to report new ones.
Post Reply
Paddy C
New Member
Posts: 12
Joined: Mon Aug 13, 2018 9:37 pm
Contact:

Macro Page designer crashed again

Post by Paddy C » Sun Dec 16, 2018 3:07 pm

Ok, so I started working on a Macro page and as I tried to drop a control knob.png into "Properties-Bmp" (see attached)
it froze again.
This is something I have done countless times in the past few months , with no issues.
Less than 24 hours after installing 6.2 it has crashed my system 5 times.

Could it be an incompatability issue with the control knobs I'm using (created with KnobMan?)
It would be strange because I've been using the same controls for over six months without a problem.
Attachments
crash.JPG
(77.42 KiB) Not downloaded yet

Gerrit Junge
Steinberg Employee
Posts: 161
Joined: Tue Feb 01, 2011 1:30 pm
Contact:

Re: Macro Page designer crashed again

Post by Gerrit Junge » Wed Jan 16, 2019 1:42 pm

Hi Paddy C,
can you provide me an example of your knobs that were created with Knobman and causes HALion to crash? And can you send me the HALion6.log file (path can be found in your screenshot) ?

If yes, please send it to g.junge@steinberg.de

best regards
Gerrit
Senior Quality Engineer
VST Instruments
Steinberg Media Technologies GmbH

Post Reply

Return to “Issues”

Who is online

Users browsing this forum: No registered users and 2 guests