Page 1 of 1

Guitar volume over metronome volume - cannot hear the metronome very well

Posted: Mon Sep 16, 2019 11:52 am
by hAtul
I am new to Cubase!
I started recording something (guitar, high gain) and just cannot hear the metronome very well.
I metronome volume is set to max (127).
I do hear it, but not very well. The guitar just eats it all up.
Any suggestions on how to handle this kind of situation?

Re: Guitar volume over metronome volume - cannot hear the metronome very well

Posted: Mon Sep 16, 2019 1:56 pm
by Martin.Jirsak
Hi and welcome,

If you are using Control Room, you can increase the Click volume there.

In Transport > Metronome Setup > Click Sounds, you can also choose a different Audio sound, if this typical Cubase sound doesn't fit to you.

Re: Guitar volume over metronome volume - cannot hear the metronome very well

Posted: Wed Sep 18, 2019 6:03 pm
by hAtul
Martin.Jirsak wrote:
Mon Sep 16, 2019 1:56 pm
Hi and welcome,

If you are using Control Room, you can increase the Click volume there.

In Transport > Metronome Setup > Click Sounds, you can also choose a different Audio sound, if this typical Cubase sound doesn't fit to you.

That's exactly what I did, max volume is 127.
The guitar sound is outputted directly from my audio interface, should I channel it to only cubase or something like that?