Page 1 of 1

AXR and Nuendo 10

Posted: Wed Aug 07, 2019 11:52 am
by Hansgiant
Is the AXR meant to run with Nuendo 10?

I am running it but it feels like a hack. All the tutorials are for Cubase with even the AXR manual referring only to Cubase.

I would like to use the AXR extension which apparently brings up a separate control page for the AXR in the inspector in Cubase - giving you direct control of the audio interface directly from Cubase(As per the manual page 56)
Does anyone know if the AXR extension can be used in Nuendo 10? My experience is that it doesnt but perhaps I'm wrong.

I would appreciate any comments or support.

Best,


Hans

Re: AXR and Nuendo 10

Posted: Thu Aug 08, 2019 8:25 am
by Hansgiant
Now there is one for the books.
Steinberg you screwed this one up royally.
You cannot access the AXR directly from either Cubase or Nuendo if you use the control room. Yep! Go figure!
The AXR control panel only becomes active in the inspector if you run direct in's and outs. this cuts out the control room.

If you use the control room in either of these applications, DONT BUY this Audio interface if you want to control the interface from you DAW.

I am disappointed!

Re: AXR and Nuendo 10

Posted: Sun Aug 25, 2019 4:04 pm
by fuzzydude
For real!!! This just has to be an oversight or a bug, it can't be a part of the feature set. I haven't checked the manual but have Steinberg said anything to you regarding this issue via support etc (I'm assuming you may have contacted them).