Page 1 of 1

Very low volume on inputs ... help!

Posted: Mon Aug 06, 2018 10:03 am
by Daisuk
Hi there! I have a very strange issue with my Steinberg MR816. I'm sending a stereo out of a few synths into the various inputs of the MR816, but the input level is so extremely low I can barely hear it! I don't have PAD engaged on any of the inputs, and neither the phantom power. I've been in the DSP mixing console, and have tried to "master" and "daw" level as well as the individual levels for the various channels, but the highest I can get the sound of the inputs is just not right, lots of noise, and I'm amping everything to the max. Listening to my synths through two different mixers work just fine, normal volume, so the MR is definitely the culprit here.

It's just that I can't figure out which setting is causing it. Strangely, when using the MR yesterday, I had normal levels on the inputs, not sure what the hell is causing it. I have moved studios recently, but the only change is really getting new monitors in, otherwise the setup is exactly like before.

To be fair I've always found the routing of the mixing console to be a bit of a mystery, it's not very intuitive to me, so it could be some connection in there, but I'm not seeing what I've setup wrong - I should be getting sound on the inputs.

But basically, I have line level going into the MR - levels in the mixer are set to 0 (normally I have them set to -10 db), but I can barely barely make out any sound coming through the phones. And yes, I've checked the phones levels as well - if I max them up, I hear the sound quite low, very noisy. I also have an ADAT unit connected to the MR for more inputs, but I get the low sound regardless of whether it is on or off. The synth directly into the ADAT works fine, by the way.

What could possibly be causing this? Bad firewire cable? I've tried various audio cables, all with the same result. Really frustrating! Any kind of help on this would be much appreciated. :)

Re: Very low volume on inputs ... help!

Posted: Tue Aug 07, 2018 9:48 am
by Daisuk
Nevermind! It was the effects unit I had connected to the insert 1/2 that was the culprit!