I was running a simple alignment check and discovered that a Steinberg Tools signal generator inserted on a stereo output bus reads exactly as it is supposed to ( same for mono )
However, when I create a 5.1 output bus the same generator ( or the mixer meter reading ) is off, and uneven across the output channels…
I’m new to to 5.1 setups, ( 2.0 work for over 20 years …) just wanted to calibrate my whole system.
What is going on ?
Yea…Inserting the generator on the 5.1 output bus shows it fine, just like you demonstrated.
I was on an audio channel , feeding the 5.1 out.
I’ll need to figure out how to set up the busing/panning correctly, as I’m just getting into the surround mixing…
I know…