Disabling Note off status byte

nealeedee2019 · Post by **nealeedee2019** » Wed May 15, 2019 8:19 pm

Hi. I would like to know if there is anyway to stop the 'Note off' status byte (during MIDI transmission), from being sent from Cubase Artist 9.5. Thanks

Post by **-steve-** » Wed May 15, 2019 8:35 pm

None that I know of.

nealeedee2019 · Post by **nealeedee2019** » Thu May 16, 2019 7:33 pm

Thank you.

Post by **-steve-** » Thu May 16, 2019 7:58 pm

May I ask what you need to accomplish? Maybe there's another method...

nealeedee2019 · Post by **nealeedee2019** » Sun May 19, 2019 6:35 pm

I'm programming a light show from a MIDI track and to get very smooth dimming ( and as quite a few lights are being dimmed) a lot of bytes need to be sent. I built a MIDI to DMX converter and it programmed to only respond to note 'Values', not Note off's. So I was thinking if there was a way of thinning out the data.. Thanks.

Post by **-steve-** » Sun May 19, 2019 7:11 pm

Ah, I understand. Not from inside Cubase, as far as I know.

Can you program a filter in your device? Otherwise, something like Bome Midi Translator, or even MIDI-OX might be able to filter out those messages.

raino · Post by **raino** » Sun May 19, 2019 10:09 pm

The tools Steve mentioned will probably get what you want.

But if not, and if you are OK with a bit of programming, then the ChucK programming language (Cal Arts) should easily do it. I suspect you'd find that ChucK is useful in other ways for what you are doing.

Disabling Note off status byte

Disabling Note off status byte

Re: Disabling Note off status byte

Re: Disabling Note off status byte

Re: Disabling Note off status byte

Re: Disabling Note off status byte

Re: Disabling Note off status byte

Re: Disabling Note off status byte

Who is online