Use this forum for an overview of collected bugs and to report new ones.
3 posts • Page 1 of 1
- New Member
- Posts: 1
- Joined: Wed Dec 05, 2018 12:12 am
After testing a macro design, I found that the keys that trigger one of my samples are an octave lower than they should be. No matter how I change the key range or root key for that zone in the mapping editor, the zone can only be triggered by keys an octave lower. I have no idea how it happened, and I can't figure out how to correct it anywhere. You can see from the screenshot that the zone is mapped to a specific range, but is only triggered by the highlighted keys an octave lower. Please help.
- Steinberg Employee
- Posts: 190
- Joined: Tue Feb 01, 2011 1:30 pm
Users browsing this forum: No registered users and 0 guests