UR242 Gain Control does not work properly

This section is about Steinberg's UR and UR-RT USB audio interfaces product range
Post Reply
zpz97zpz
New Member
Posts: 2
Joined: Thu Jun 13, 2019 11:57 pm
Contact:

UR242 Gain Control does not work properly

Post by zpz97zpz »

Hi there,

I have got a UR242 last year and it is been working very well since then. However, a few weeks ago after I turned the UR242 off then turned it back on. The input from the microphone is very low that I could barely hear anything unless I turned the gain control to the max. (Even I turned off the PAD)

It used to let me adjust the gain control to change the input volume, even I turned to a low gain I could still hear something quite clear with low volume from the microphone. Now, I could only hear the microphone when the gain control is turned to max.

I have contacted the seller that my product is still under warranty and they have swapped a completely new device. The issue is still there.

The devices I have is UR242 audio interface, Rode NT1 and Sennheiser HD 380 Pro headphone with Windows 10.

I have also attached the recording capture comparison with the same settings I used to have.

Just wondering what causes this problem and is this happening to other people as well.

Thank you. :D
Attachments
Now.png
(65.07 KiB) Not downloaded yet
Before.png
(174.21 KiB) Not downloaded yet

-steve-
External Moderator
Posts: 9670
Joined: Wed Dec 15, 2010 7:42 pm
Contact:

Re: UR242 Gain Control does not work properly

Post by -steve- »

I mean, is phantom power turned on?
independent manufacturer rep (not a Steinberg employee)
[safe mode] [cubase manual] [score editor manual]

zpz97zpz
New Member
Posts: 2
Joined: Thu Jun 13, 2019 11:57 pm
Contact:

Re: UR242 Gain Control does not work properly

Post by zpz97zpz »

If what you mean is the +48v, then yes it is on the whole time.

Post Reply

Return to “Steinberg UR Series”

Who is online

Users browsing this forum: No registered users and 0 guests