CI1 separating inputs on OSX/Mainstage

This section is about Steinberg's USB audio interfaces CI1, CI2 and CI2+
Post Reply
authoreyes
New Member
Posts: 2
Joined: Sat Jun 02, 2012 3:01 pm
Contact:

CI1 separating inputs on OSX/Mainstage

Post by authoreyes » Sat Jun 02, 2012 3:22 pm

Hi,

Sorry if this is a stupid question or not possible, but I am using the CI1 with Mainstage 2 on OSX.

When I configure a song, I create a new channel strip, with has an input source of input 1-2 (which is the correct CI1 device)

I want to be able to use this live, so I have guitar in line 1, vocals in line 2 plugged into the CI1.

In Mainstage, I have an insert on channel strip 1 of Peavey Revalver for my guitar pre-amp/effects, but it applies the same effect to the mic in line 2.

Is there a way to separate the in's as 2 separate channel strips so I don't apply Revalver to the mic in?

authoreyes
New Member
Posts: 2
Joined: Sat Jun 02, 2012 3:01 pm
Contact:

Re: CI1 separating inputs on OSX/Mainstage

Post by authoreyes » Sat Jun 02, 2012 9:41 pm

Never mind,

Stupid question...Figured it out...The channel strip one was set to stereo - setting to mono and adding a second to take the 2nd input worked like a charm.

Post Reply

Return to “Steinberg CI Series”

Who is online

Users browsing this forum: No registered users and 5 guests