CuBase LE 5 Static Noises Everywhere

All about our Cubase LE and Cubase AI OEM bundle software.
Post Reply
odinn1984
New Member
Posts: 1
Joined: Fri Dec 20, 2013 9:20 am
Contact:

CuBase LE 5 Static Noises Everywhere

Post by odinn1984 » Fri Dec 20, 2013 9:23 am

I bought a Lexicon Lambda interface and connected it to my MacBook Pro late 2011.

Specs:

Intel core i5 2.4GHz
16GB Ram
512GB SSD
OSX 10.9
Lexicon Lambda (Connected via USB to computer)
Samson Graphite 49 (Connected via USB to computer)

I installed CuBase LE 5 and then tried recording a sound with my microphone.
When I plug in the microphone to any of the inputs on the card I get terrible static noises even before playback or record... Just by pressing monitor... Same with the graphite controller, when I play on it the notes are distorted...

What I tried to do:

Restart the system
Install a patch from Steinberg's site
Use another cable
Use another USB port
Disconnect everything and try only with the interface
Trying every sample rate that CuBase showed me
Trying Mono and Stereo
Different volume and monitor levels on the interface
Different sockets on the interface

And then... I tried GarageBand... Which worked perfectly fine so what's the problem with CuBase why do I get static noises when I use it?

insub
New Member
Posts: 24
Joined: Thu Nov 21, 2013 4:26 am
Contact:

Re: CuBase LE 5 Static Noises Everywhere

Post by insub » Fri Dec 27, 2013 6:15 pm

Sounds like the latency of your card is set too low, or you are not using the correct driver selected from within Cubase. Go to Devices > Device Setup... > VST Audio System > Select the proper ASIO driver (not sure if Mac uses ASIO). If already the correct driver Click the driver and select Control Panel. Increase the Buffer/Latency size.
Cubase Elements 7, SX2, Win7 x64, MOTU 828mkII, MOTU 8Pre, Access Virus TI, Yamaha Motif ES8, Casio Privia PX-350M.

Post Reply

Return to “Cubase LE and Cubase AI”

Who is online

Users browsing this forum: No registered users and 3 guests